Starrett 798 Electronic Slide Caliper Manuel d'utilisateur télécharger pdf (Page 3)

(Note: If the display shows "Err0" after reinstalling the

battery, press the "zero on/off" button to return the tool to

its normal operation.)

BATTERY INSTALLATION

The caliper comes with one CR2032 lithium battery, not

installed. To change or install a new battery refer to Figure

First, unscrew and remove the battery cover (1) by turning

it to the left ¼ turn. Remove the old battery. Next, position

the rubber “O” ring (3) correctly in the bottom of the battery

compartment before inserting the new battery (2) negative

side (-) down. Then, re-install the battery cover (1) and lock

it into position by giving it a ¼ turn to the right.

Fig. 1

1 2 3 4 5 6 7 8 ... 19 20

Pas de commentaire

Starrett 798 Electronic Slide Caliper Manuel d'utilisateur Page 3